#ATV LOADING RAMPS HOW TO#

You’ll need to strap down the ramp before using it with the ATV, or it could slip out of place. The end of the ramps should have rubber guards, or they may scratch the truck or trailer. Steel ramps weigh more than aluminum ramps, but they are less likely to bow under the weight of the personal vehicle. Typically, you’ll select between steel and aluminum ramps. Fold downĪ loading ramp may have a bifold or trifold design, so you can fold up the length of the ramp to limit the storage space required for the ramp when it is not in use. Once you’ve settled on the size of ATV loading ramps you need, you then can focus on whether you want some of the following features. If you are riding the ATV up the ramp and have some gear attached to it, it can weigh 1,100 pounds or more. The average ATV weighs about 500 pounds, but it can weigh as much as 850 pounds. You’ll want the ramps to be a little wider than the width of the widest tires, so you reduce the risk of having the tire slip off the edges of the ramps. Measure the width of the tires of the ATV or riding lawn mower to determine the best width for the ramps. (ATV loading ramps nearly always sell as a set of two matching tracks.) LengthĪ longer ramp will allow you to have a shallower angle from the ground to the back of the truck or trailer, which makes it safer to move the vehicle up the ramp versus a sharp angled ramp. Start shopping for ATV loading ramps by determining the width and length of the tracks you need, as well as the weight they need to support. Considerations when choosing ATV loading ramps

#ATV LOADING RAMPS HOW TO#

Keep reading our guide for tips on how to find the best ATV loading ramp for your needs. It has a set of advanced features that place it at the top of the market. As long as you set up and secure the ramps properly, they are safe to use.īecause of its lightweight, yet durable design, the Yutrax Tri-Fold Ramp is our favorite ATV loading ramp. These ramps are made of metal, using a durable design so they can support plenty of weight.

When you need to load your ATV or a similar size personal vehicle into the back of a truck or trailer, having loading ramps available is extremely helpful. Please look at the time stamp on the story to see when it was last updated. Repeat the previous steps for the other ramp(s).This is an archived article and the information in the article may be outdated.Neither should be able to move out of place. There should be a balance between the straps and the ramps. Unless you have a ratchet strap, you may need to tighten the straps before finishing the previous step.Once the ends are tied, increase the tension in the straps to remove any slack. Repeat the same fastening steps as before.You should only fasten the strap to a metal area on the vehicle: built-in hooks or somewhere on the frame. Secure the strap to the loading vehicle.If the ramp has a center rail, wrap the strap around that instead of a rung.

For D-ring straps, secure the ramp end by wrapping the D-ring around the rung and clamping onto the strap on the other side.

If you have a basic hook-and-loop strap, loop the hook through at the ramp so it remains attached to the ramp.

Aim for one of the first few rungs closest to the vehicle since a shorter strap length will help keep things stable.

Run a safety or ratchet strap through a rung on a ramp.

Atv loading ramps